◎Put the eye in the recess inside the head.
Put the eyes into the eyehouls of the head.
◎ The eye protrusions on the eye attachment device
Use a magnet to secure it in place.
Fix the eyes with the two circles of the fitment and the magnets.
◎ Look at it from the front and fine-tune the position to finish!
It is completed if you see the front of the face and it is no problem.
◎It is attached only by magnets,
Just a little tug will remove it.
When attaching, align it with the hole on the head.
Please put it on slowly.
Join the neck to the lower side
of the head causiously.
They can be dislocated, beacase
they are connected with mafnets.
◎It can be removed by pulling it with your hand.
When attaching, press it into the recess.
will be included.
*This is a very delicate part,
Please be careful when handling.
If you pull the back part of the head,
it is dislocated from the flint one.
When you join two of them,
Please connect the bump and the dent.
*This product is delicate, so
Please pay attention not to damage it.